- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Removing the base cover
- Replacing the base cover
- Removing the battery
- Replacing the battery
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the hard drive
- Replacing the hard drive
- Removing the wireless card
- Replacing the wireless card
- Removing the display assembly
- Replacing the display assembly
- Removing the I/O board
- Replacing the I/O board
- Removing the speakers
- Replacing the speakers
- Removing the status-light board
- Replacing the status-light board
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the touchpad
- Replacing the touchpad
- Removing the system board
- Replacing the system board
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the palm-rest and keyboard assembly
- Replacing the palm-rest and keyboard assembly
- Downloading drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 14 7000 Service Manual
Running the ePSA Diagnostics
Invoke diagnostics boot by either of the methods that are suggested below:
- Power on the computer.
- As the computer boots, press the F12 key when the Dell logo is displayed.
- In the boot menu screen, use Up/Down arrow key to select the Diagnostics option and then press Enter. NOTE The Enhanced Pre-boot System Assessment window displays, listing all devices detected in the computer. The diagnostics starts running the tests on all the detected devices.
- Press the arrow in the lower-right corner to go to the page listing.The detected items are listed and tested.
- To run a diagnostic test on a specific device, press Esc and click Yes to stop the diagnostic test.
- Select the device from the left pane and click Run Tests.
- If there are any issues, error codes are displayed. Note the error code and contact Dell.
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
この記事は役に立ちましたか?
コメントでは、以下の特殊文字は利用できません: <>()\