Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge T320 Systems Owner's Manual

PDF

Removing The System Board

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  • CAUTION: If you are using the Trusted Program Module (TPM) with an encryption key, you may be prompted to create a recovery key during program or system setup. Be sure to create and safely store this recovery key. If you replace this system board, you must supply the recovery key when you restart your system or program before you can access the encrypted data on your hard drives.
  1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
  2. If applicable, rotate the system feet inward and lay the system on its side on a flat, stable surface.
    • NOTE: For systems installed with the wheel assembly, ensure that you lay the system on a sturdy, stable surface with the wheel assembly extending off the edge of the surface.
  3. Open the system.
  4. Remove the following as applicable:
    1. cooling shroud
    2. system cooling fan
    3. PCIe card holder
    4. iDRAC ports card
    5. all expansion cards
      • WARNING: The heat sink and processor are hot to the touch for some time after the system has been powered down. Allow the heat sink and processor to cool before handling them.
    6. heat sink and processor
    7. memory modules
    8. internal dual SD module
    9. internal USB key
  5. Disconnect all cables from the system board.
    • CAUTION: Take care not to damage the system identification button while removing the system board from the chassis.
  6. Remove the 11 screws that secure the system board to the chassis.
  7. Grasp the system-board holders and slide the system board towards the front of the system.
    • CAUTION: Do not lift the system board assembly by grasping a memory module, processor, or other components.
    Figure 1. Removing the System Board The figure shows removing and installing the system board.
    1. screws (11)
    2. system-board holders (2)
    3. system board

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\