Ga naar hoofdinhoud
  • Snel en eenvoudig bestellen
  • Bestellingen en de verzendstatus bekijken
  • Een lijst met producten maken en openen
  • Beheer uw Dell EMC locaties, producten en contactpersonen op productniveau met Company Administration.

Dell Lifecycle Controller GUI v2.30.30.30 User's Guide

Deleting or changing an existing system and/or setup password

Ensure that the Password jumper is set to enabled and the Password Status is Unlocked before attempting to delete or change the existing System and/or Setup password. You cannot delete or change an existing System or Setup password if the Password Status is Locked.
To delete or change the existing System and/or Setup password:
  1. To enter System Setup, press <F2> immediately after a power-on or restart.
  2. In the System Setup Main Menu, select System BIOS and press <Enter>. The System BIOS screen is displayed.
  3. In the System BIOS Screen, select System Security and press <Enter>. The System Security screen is displayed.
  4. In the System Security screen, verify that Password Status is Unlocked.
  5. Select System Password, alter or delete the existing system password and press <Enter> or <Tab>.
  6. Select Setup Password, alter or delete the existing setup password and press <Enter> or <Tab>.
    • NOTE: If you change the System and/or Setup password a message prompts you to re-enter the new password. If you delete the System and/or Setup password, a message prompts you to confirm the deletion.
  7. Press <Esc> to return to the System BIOS screen. Press <Esc> again, and a message prompts you to save the changes.
  • NOTE: You can disable password security while logging on to the system. To disable the password security, turn on or reboot your system, type your password and press <Ctrl><Enter>.

Beoordeel deze inhoud

Nauwkeurig
Nuttig
Eenvoudig te begrijpen
Was dit artikel nuttig?
0/3000 characters
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Selecteer of het artikel nuttig is of niet.
  Opmerkingen mogen geen speciale tekens bevatten: <>() \