Dell OpenManage Deployment Toolkit Version 4.3 User's Guide

Running RACCAP.BAT Or raccap.sh

To run the RACCAP.BAT or raccap.sh sample script to capture the RAC configuration information in the raccfg.ini file:

Edit the startnet.cmd file (on your Windows PE image) or start-up script file (on your embedded Linux image) to call the RACCAP.BAT or raccap.sh script after the network share with the pre-built DTK directory structure is mounted. For example, add: On systems running Windows:
```
Z:\Dell\x32\Toolkit\Template\Scripts\RACCAP.BAT Z:\raccfg.ini
```
On systems running Linux:
```
/opt/dell/toolkit/template/scripts/raccap.sh
```
Boot the source system into Windows PE or embedded Linux. The script runs and saves the configuration information in the \Toolkit\Systems\<target system> directory on systems running Windows and /opt/dell/toolkit/systems/<target system> directory on systems running Linux.
Edit the startnet.cmd file (Windows PE image) or start-up script file (embedded Linux image) to remove the text you added in step 1.
- NOTE: The RAC configuration file is referred to as the .cfg file in the Integrated Dell Remote Access Controller 6 (iDRAC6) Enterprise for Blade Servers User Guide and the Dell Remote Access Controller 4 User’s Guide . See these guides for additional information about manually creating a RAC configuration file.
- NOTE: Do not replicate the RAC IP address when creating a .cfg file. Replicating the RAC IP address can leave the system inaccessible because multiple systems are configured with the same IP address.
- NOTE: On Dell PowerEdge 9G or later systems, raccap.sh and syscap.sh have duplicate functions. If you run raccap.sh followed by syscap.sh, the latter overwrites the former settings.

Damos-lhe as boas-vindas

Damos-lhe as boas-vindas à Dell

Dell OpenManage Deployment Toolkit Version 4.3 User's Guide

Running RACCAP.BAT Or raccap.sh

Classifique este conteúdo