- Notes, cautions, and warnings
- Getting Started
- What’s new in this release
- DUP event viewer
- Zip pack elimination
- Slot information for hard drive
- Dependency
- Supported Operating Systems
- Prerequisites
- Prerequisites And Features For Systems Running Linux
- Prerequisites and Features for Systems Running Windows
- Downloading DUPs
- Downloading DUPs through Repository Manager
- Installing Device Drivers
- Installation Order of DUPs
- Best practices for using DUPs
- Other Documents You May Need
- Contacting Dell
- Using Dell Update Packages
- Update and Rollback in Lifecycle Controller Enabled Server
- Command Line Interface Reference
- Linux Troubleshooting
- Known Issues
- Diagnostic Tasks Will Not Run While a DUP Reboot is Pending
- Abnormal Termination of a DUP
- Error While Loading Shared Libraries
- Insufficient Free Physical Memory to Load the BIOS Image
- Kernel Panic While Running Storage Controller Firmware Update Packages
- Loss of Functionality While Renaming Linux DUPs
- DUPs Fail on 64-bit Red Hat Enterprise Linux Operating System
- DUP Update of Firmware Might Fail While Running in the UEFI Mode
- Messages
- DUP Message Logs
- Known Issues
- Troubleshooting for Systems Running Windows
- Trusted Platform Module and BitLocker Support
- Microsoft Windows Server 2008 User Account Control
- Frequently Asked Questions
Dell Update Packages User's Guide
UAC Restrictions When Running DUPs Remotely
By default, after UAC starts, all Administrator Account users login as Standard Users. Thus, rights to access critical system resources are not available until the user confirms the privilege elevation request. This restriction disables the option to remotely deploy DUPs. UAC returns an Access Denied error if the management node agent runs on these login credentials.
You can bypass the UAC restrictions by:
- Enabling remote agent use of the Local System Account to perform a DUP update. The Local System Account is not protected by UAC (recommended option).
- Using the Local Administrator Account on each remote machine where the DUP is running.
- Disabling UAC for all users on remote machines (not a recommended option).
- Not upgrading to Administrator account on remote machines.
- NOTE: Only two accounts (the Local Administrator Account and the Local System Account) are not protected by UAC. All other users including accounts with local administrator rights or domain administrator rights have UAC enabled by default. Even though UAC can be disabled by updating the local or domain security policy, it is not recommended. Remote users have to login as a built-in Local Administrator Account or obtain the Local System Account privilege to launch a DUP remotely.
Поставьте оценку (1–5 звезд).
Поставьте оценку (1–5 звезд).
Поставьте оценку (1–5 звезд).
Выберите ответ на вопрос, была ли статья полезной.
Комментарии не должны содержать следующие специальные символы: <>()\