- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Removing the base cover
- Replacing the base cover
- Removing the wireless card
- Replacing the wireless card
- Removing the hard drive
- Replacing the hard drive
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the memory modules
- Replacing the memory modules
- Removing the rear-I/O cover
- Replacing the rear-I/O cover
- Removing the computer base
- Replacing the computer base
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the battery
- Replacing the battery
- Removing the touch pad
- Replacing the touch pad
- Removing the keyboard
- Replacing the keyboard
- Removing the I/O board
- Replacing the I/O board
- Removing the speakers
- Replacing the speakers
- Removing the system board
- Replacing the system board
- Removing the heat-sink assembly
- Replacing the heat-sink assembly
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the power-button board
- Replacing the power-button board
- Removing the palm rest
- Replacing the palm rest
- Removing the display assembly
- Replacing the display assembly
- Removing the display bezel
- Replacing the display bezel
- Removing the display panel
- Replacing the display panel
- Removing the camera cable
- Replacing the camera cable
- Removing the display hinges
- Replacing the display hinges
- Removing the display back-cover and antenna assembly
- Replacing the display back-cover and antenna assembly
- Removing the camera
- Replacing the camera
- BIOS overview
- Diagnostics
- Getting help and contacting Alienware
Vitajte
Vitajte v spoločnosti Dell!
Moje konto
- Zadávajte objednávky rýchlo a jednoducho
- Pozrite si svoje objednávky a sledujte priebeh doručenia
- Vytvorte si zoznam svojich produktov a majte ho vždy poruke
- Spravujte svoje lokality Dell EMC, produkty a kontaktné informácie na úrovni produktov pomocou Správy informácií o spoločnosti.
Alienware 15 R3 Service Manual
Procedure
- Align the screw holes on the display hinges with the screw holes on the display back-cover.
- Replace the 14 screws (M2.5x3) that secure the display hinges to the display back-cover .
- Route the antenna cables, display-board cable, and display cable through the routing guides on the display back-cover .
- Turn the display assembly over.
- Place the hinge caps on the display hinges and press down to snap them into place.
Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
Vyberte, prosím, hodnotenie (1 až 5 hviezdičiek).
Vyberte, prosím, či vám článok pomohol alebo nie.
Poznámky nemôžu obsahovať nasledujúce špeciálne znaky: <>()\