iDRAC Service Module 1.0 Installation Guide

Copy and unzip the ISM-Dell-Web-1.0.0-<bldno>.VIB-<version>i.zip file to a directory on the system.

Shut down all guest operating systems on the ESXi host and put the ESXi host in maintenance mode.

If you are using vSphere CLI on Windows, go to the directory where you have installed the vSphere CLI utilities. If you are using vSphere CLI on Linux, perform the command from any directory.

Perform the following command: For VMware ESXi 5.1: esxcli --server <IP Address of ESXi 5.1 host> software vib install -d /var/log/vmware/<iDRAC Service Module file>. For VMware ESXi 5.5: esxcli --server <IP Address of ESXi 5.5 host> software vib install -d /var/log/vmware/<iDRAC Service Module file>.

NOTE: The .pl extension is not required if you are using vSphere CLI on Linux.

Type the root username and password of the ESXi host when prompted. The command output displays a successful or a failed update.

Restart the ESXi host system. To get or list the information about the installed VIBs, use esxcli --server <IP>software vib get or software vib list.

iDRAC Service Module 1.0 Installation Guide

Using The vSphere CLI

對此內容評分

歡迎

歡迎來到 Dell

iDRAC Service Module 1.0 Installation Guide

Using The vSphere CLI

對此內容評分