How to set up and use 2 different internal network on avamar single node without NAT or VLAN

Hello everyone,

Recently, I installed avamar single node on my site - Gen4, Avamar6.1 on SLES.

There are 2 differenet clients on avamar and they are in different internal networks.

I want to use NIC1(eth0) for A client, NIC2(eth1) for B client. (Because of eth0-eth2 bonding by default, I heard.)

And I don't want to set NAT or VLAN function on avamar, just use 1NIC on 1client for each network.

Client A's IP is 211.x.x.x and client B's IP is 121.x.x.x.

(from A client's switch and B client's switch)

Now, client A is on backup service. I'll configure network setting for client B on avamar soon.

How to set up client B network in this avamar?

Just configure NIC2 with 'yast'??

Or is there any procedure needs? (like 'dpnnetutil' or avamar restart .. or something)

And if I have to restore some data on the client later,

restore from admin GUI is possible?

If I don't use bonding on avamar, all of 4 NIC is usable for each network??