Unsolved
This post is more than 5 years old
2 Intern
•
193 Posts
0
672
March 9th, 2009 06:00
IP Change - AX150
I am looking to change the ip on my AX150 storage . is this is the same procedures as the CX family.
using the the "Clariion procedures genartor" when trying to run for AX150 i am getting a massgae theat i need to refer into emc.com/axsupport45
is there any doc for changing ip on the AX150?
tx
using the the "Clariion procedures genartor" when trying to run for AX150 i am getting a massgae theat i need to refer into emc.com/axsupport45
is there any doc for changing ip on the AX150?
tx
No Events found!
RyanP2
261 Posts
0
March 12th, 2009 14:00
http://www.emc.com/microsites/clariion-support/ax150/
1. Un-initialize the storage system.
Step 1 Further Instructions:
How do I un-initialize an AX-series storage system?
When you un-initialize a storage system, you remove the user name and password, allowing you to create new ones. You also may change the management port IP addresses at this time.
To un-initialize an AX150-series storage system:
1a. Power down the storage system by pressing the power button located on the back panel of the storage system. The SP boot LED flashes and the storage system shuts down after several seconds.
1b. Wait for approximately one minute after the storage system powers down completely.
1c. Press and hold the power button for 4 to 8 seconds, and then release it. When you release the button, the SP boot LED begins to flash.
1d. When the SP boot LED stops flashing, the storage system is powered up in an uninitialized state.
Note You may now create a user name and password and/or change the management port IP addresses through the Navisphere Initialization Utility. Once you reboot the storage system, you will not be able to change them unless you repeat the procedure above to unitialize the storage system.
2. Wait until the storage system powers up, and then start the Navisphere Initialization Utility.
Step 2 further Instructions:
How do I start the Navisphere Initialization Utility?
Microsoft Windows
To start a pre-installed copy of the Navisphere Server Utility, click Start > Programs > EMC > Navisphere > Navisphere Storage System Initialization. This opens the Welcome screen.
-or-
To run the server utility from the AX-Series Service Support CD that shipped with the AX-100 storage system:
2a. Insert the CD in the CD ROM drive of the server that does not see the virtual disks.
2b. From the main menu of the AX-Series Service Support CD, click Run Products from the CD.
2c. In the Run Products screen, click AX-Series Storage System Initialization. This opens the Welcome screen.
3. Click on the storage system entry in the Uninitialized Systems column.
4. Click Next.
5. Enter the network parameters.
6. Click Next.
7. Create a username and password.
8. Click Next.
9. Click Finish to finish the initialization or Back to change the settings.