Unsolved
This post is more than 5 years old
27 Posts
0
2615
Power down guide for VNX block device
I know the power down guide come in the link below .
https://russia.emc.com/collateral/TechnicalDocument/docu41465.pdf
DAE and DPE do not have rocker/micro switches to power down.
My understanding is that system will auto boot when we connect the system to power (DAE first and DPE last).
Experts out there, I would appreciate your help.
Will system power off via Unisphere UI will turn DAE and DPE off and the LEDs will be turned off ? Is there any other way to power down and restart the system if the power off and restart do not work as explained on the manual above?
brettesinclair
715 Posts
1
October 2nd, 2016 04:00
The DPE will be powered off but DAE's will remain powered on until you intervene.
There will be some LEDs on that indicate whether the system is ready for the switches on the DPE to be turned off.
You can get detailed instruction by creating a doc on https://mydocuments.emc.com/
Nagbh
1 Message
0
August 31st, 2022 19:00
Unable to view the document
DELL-Sam L
Moderator
Moderator
•
6.9K Posts
0
September 1st, 2022 01:00
Hello mutthu,
Here is a link to a kb for VNX power up/down procedures.
https://dell.to/3Q4eJXJ
Praveen.Singh
3 Apprentice
3 Apprentice
•
405 Posts
0
March 11th, 2023 22:00
use this link:-
https://www.scribd.com/document/396651353/VNX-Power-UP-Down-Procedure
accept it as a solution if the issue is resolved