Unsolved
This post is more than 5 years old
2 Intern
•
232 Posts
0
764
June 29th, 2008 05:00
San Boot on Solaris
Hi,
I would like to configure Sun Fire V490 servers to boot on a SAN made
of CX3-40.
Please give me the hints (procedure or steps) if you expirienced that.
Thanks
Consty
I would like to configure Sun Fire V490 servers to boot on a SAN made
of CX3-40.
Please give me the hints (procedure or steps) if you expirienced that.
Thanks
Consty
No Events found!
undertaker98
75 Posts
0
June 30th, 2008 04:00
Fibre Channel with QLogic Host Bus Adapters in the Solaris Environment
http://powerlink.emc.com/nsepn/webapps/btg548664833igtcuup4826/km/live1/en_US/Offering_Technical/Technical_Documentation/300-001-163_a06_elccnt_0.pdf?mtcs=ZXZlbnRUeXBlPUttQ2xpY2tTZWFyY2hSZXN1bHRzRXZlbnQsZG9jdW1lbnRJZD0wOTAxNDA2NjgwMjdhYzZjLGRhdGFTb3VyY2U9RENUTV9lbl9VU18w
And you can search some info about it on HBA vendor website.
If you use a powerpath, check admin guide for powerpath in solaris environment
Home > Support > Technical Documentation and Advisories > Software ~ P-R ~ Documentation > PowerPath > Installation/Configuration
Message was edited by:
undertaker98