Unsolved
This post is more than 5 years old
1 Message
0
757
Standby status in Powerpath:
why does a path goes into standby status? Is is because of more number of targets zoned to the HBA? We have a scenario where in 9 FA ports are zoned and one of the paths zoned to the 9th FA is showing as Standby status. I'm assuming that maximum of 8 connections can show active on one HBA and if it exceeds it will go into standby status by default. Am I correct?
dynamox
1 Rookie
1 Rookie
•
20.4K Posts
0
November 1st, 2014 12:00
is PowerPath licensed ? symopt policy set on all devices ?