Unsolved
This post is more than 5 years old
7 Posts
0
478
Using VDS feature against CX3-20f
Hi,
I'm trying to configure the VDS on a windows 2008 R2 to manage the CX3-20f connected to the server. I've followed the documents from EMC but I don't know what I'm doing wrong... the service doesn't work... It run without an error a couple ot times but all the options were on grey and I didn't see any LUN connected to the system... I installed more software (VSS module) and now it doesn't work... I have uninstalled all (VDS and VSS)... Do you have a clear procedure to install and configure the service?.
PD. I've downloaded the following versions:
se7210-WINDOWS-x64-VSS.exe
se7210-WINDOWS-x64-VDS.exe
I have installed the Powerpath, Host Agent, Navisphere CLI and Server Utils software in the host.
Thanks in advanced.
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
June 1st, 2011 09:00
what are you trying to do ?
ecemibm
7 Posts
0
June 1st, 2011 10:00
I'm trying to configure the SAN tranfers feature in the system center virtual machine manager... and as far as I know the windows server has to manage the LUNs between the hosts (mount and umount them)... the system asks me about VDS installation...