Unsolved
This post is more than 5 years old
31 Posts
0
443
powerpath 5.0 with CX700 rev 24 not adding new path to hosts
Hello,
I've a windows box with powerpath 5.0. I've added a new path to the 2 SPs in order to rearrange the current path. I'm a little bit confused because I clearly see the new CXs ports in HBA Anywhere but nothing in Powerpath. I've run the powermt check reconfig and I still don't see the new paths.
can someone help my figuring out why it's not taking the new paths?
many thanks
I've a windows box with powerpath 5.0. I've added a new path to the 2 SPs in order to rearrange the current path. I'm a little bit confused because I clearly see the new CXs ports in HBA Anywhere but nothing in Powerpath. I've run the powermt check reconfig and I still don't see the new paths.
can someone help my figuring out why it's not taking the new paths?
many thanks
Kiran3
410 Posts
1
February 21st, 2008 05:00
you need to run "powermt config" to detect new paths and "powermt save" to save the information.
if this still cant detect the new paths, you probably need to restart the host!
Eric.Krejci
31 Posts
0
February 22nd, 2008 00:00
actually I don't see the new path unless I reboot. but I would like to the addition without restarting the host.