Unsolved
This post is more than 5 years old
6 Posts
0
683
ISCSI mapping
This is my setup. I downloaded Celerra lite and opened with the VMplayer. I assigned an ip address on the eth0 interface using the net config command.
Then I created a file system and created a target and mapped to LUN that I created. now I am trying to map that LUN to the PC where I am running the simulator. Eth0 and the PC on the same subnet. I cant seem to map the LUN and not sure what am I missing.
I do see e|30 and e|31 with 128 ip addresses and not sure what there are used for.
Any help is appreciated
Then I created a file system and created a target and mapped to LUN that I created. now I am trying to map that LUN to the PC where I am running the simulator. Eth0 and the PC on the same subnet. I cant seem to map the LUN and not sure what am I missing.
I do see e|30 and e|31 with 128 ip addresses and not sure what there are used for.
Any help is appreciated
alias23122
139 Posts
0
October 2nd, 2009 13:00
Kaiser1_780b57
6 Posts
0
October 5th, 2009 10:00
Thx
Kaiser1_780b57
6 Posts
0
October 13th, 2009 11:00
Thx
Rainer_EMC
8.6K Posts
0
November 2nd, 2009 03:00
easiest way is to setup the ISCSI part through the wizard in Celerra Manager