Unsolved
This post is more than 5 years old
72 Posts
0
1771
Questions about Powercycle , upload pxe image on Centera Nodes
Hello
Was viewing some Primus Solutions regarding Centera Offline Nodes
About Powercycling : shall i connect ssh to Centera node then run command
sudo FPipmitool --reset c001n02
as emc206040 tells
if not ssh using which tool ?
other ways to powercycle ?
and how to upload latest pxe image to some node ? where should i find the image ?
using pscp
with such command for the image
pscp -v c:\"my documents"\file.foo username@nber.org:file.foo
then after upload how to install
how do i find current pxe version
regards
SamiEMC
72 Posts
0
November 3rd, 2010 02:00
ok found rescue-pxe-4.1.116_install.bin in C:\Program Files\Centera ProcGen\Tools
and reading there is two ways to setup
1 via cli and second via cv
Phukon
337 Posts
0
November 9th, 2010 07:00
Hi,
If you are unable to manual reset on the node yet, For Remote options you may require additional privileges apart from the admin profile. Yes we can perform a panel reset using the ssh mode, However If the node is still offline you may create a Ticket with EMC support.
regards,
Phukon.