This post is more than 5 years old
1 Rookie
•
12 Posts
0
2808
SC 4020 first config
Hi, I have a SC4020 bay and I have not the serial cable that comes with it ?? !!! Is there a way to make the first configuration (IP address management) without using the serial cable Is that I can have the cable of reference so that I can order it ?? Thank you.
trodai0080
1 Rookie
1 Rookie
•
40 Posts
0
October 10th, 2016 07:00
You will need to contact Dell with regards to the License file, this is needed to unlock all of the features including the hard drive usage
These license files are specific to the unit and are non transferable
Dell may release the original license to you if you brought the unit second hand but they may charge to re license
When buying second hand compellent units especially the SC4020 you need to make sure they have the relevant licenses especially the core license as this is a right to use the compellent operating system
Dave
trodai0080
1 Rookie
1 Rookie
•
40 Posts
0
October 10th, 2016 04:00
Hi
You do need a serial cable to configure the unit, if the unit is in factory shipped condition the management ports need to be defined and enabled, there is no default ip address
The below link shows what you would need
"www.amazon.com/.../B004T9BBJC"
Dave
wahab22
1 Rookie
1 Rookie
•
12 Posts
0
October 10th, 2016 07:00
Thanks Lot
i configurr IT with DB9-JACk searla Cable.
now how i can knox service TAG of SC4020 i have juste PN AND SN ??
and how i cant mau license ???