This post is more than 5 years old
24 Posts
0
729
Cisco Blade Upgrade
Dear Sir/Madam
After installing a blade in the Cisco switch do I have to do anything?
Regards,
TKM
After installing a blade in the Cisco switch do I have to do anything?
Regards,
TKM
healyj
141 Posts
0
November 28th, 2017 06:00
Hi there,
In our effort s to clean up the forum, we came across your question / statement.
If the question / statement is still valid, not expired and you need an update please reach out again and we try to get it answered.
As for now we set it to “answered.”
Regards,
Jim
AranH1
2.2K Posts
0
October 28th, 2008 08:00
switch# show module
Mod Ports Module-Type Model Status
--- ----- -------------------------------- ------------------ ------------
1 16 1/2 Gbps FC Module DS-X9016 ok
2 32 1/2 Gbps FC Module DS-X9032 ok
3 48 1/2/4 Gbps FC Module DS-X9148 ok
4 32 Storage Services Module DS-X9032-SSM ok
5 0 Supervisor/Fabric-1 DS-X9530-SF1-K9 ha-standby
6 0 Supervisor/Fabric-1 DS-X9530-SF1-K9 active *
8 24 1/2/4 Gbps FC Module DS-X9124 ok
9 24 1/2/4 Gbps FC Module DS-X9124 ok
You should see something similar to the above with your line card listed and the status as 'ok'. If it is not powered up, go into 'conf t' and powerup the module:
switch# no poweroff module X (where x is the module number)
ConnectrixHelpe
259 Posts
0
October 28th, 2008 08:00
Thank you.