This post is more than 5 years old
3 Posts
0
737
Data Domain- Avamar
We are going ot get new installs on Data Domain, and Avamar in the next few weeks.
I am new to the backup world. Where would be a good place to get started?
Also, is there any installation instructions. For example, what are the prereqs in my environemnt that I check for?
Thanks much,
tatopani123
dynamox
1 Rookie
1 Rookie
•
20.4K Posts
0
June 27th, 2016 07:00
typically they will do the normal rack and stack , run through the configuration wizard that will configure DNS, NTP, maybe some IP related stuff, really just basic stuff. Then you take over and configure LACP/VLAN tagging if necessary, join to active directory (if required) ..etc.
dynamox
1 Rookie
1 Rookie
•
20.4K Posts
0
June 26th, 2016 06:00
product admin guides are always a great place to start. Is the install being done by EMC ? Typically they send out a site preparation checklist so you know what you need to have ready.
tatopani123
3 Posts
0
June 27th, 2016 04:00
Dear dynamix,
Yes, an EMC support personal will come, and do the setup. I wanted to be ready when he comes in as far as preparation on our end goes. Do you have any suggestions?
Also, I will look for the products guides, thanks!
Tatopani