Unsolved
This post is more than 5 years old
3 Posts
0
740
VTL replication status for specific barcode
We're searching for a way to use the CLI to query the local DD2500 for the status of a specific barcode being replicated to the remote DD2500. This would let us report back when the replication for that specific barcode was complete. So far, I'm not seeing a CLI command that will provide this information.
Version is DDOS 5.6.0.5-501748
Thank you.
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
September 19th, 2016 01:00
You can use the CLI command: "vtl tape show".
Example:
# vtl tape show all barcode T10007LA
Processing tapes....
Barcode Pool Location State Size Used (%) Comp Modification Time
-------- ------- -------- ----- ----- ---------------- ---- -------------------
T10007LA DDVTL01 vault RW 1 GiB 0.0 GiB ( 0.00%) 0x 2013/02/28 14:26:35
-------- ------- -------- ----- ----- ---------------- ---- -------------------
VTL Tape Summary
----------------
Total number of tapes: 1
Total pools: 1
Total size of tapes: 1 GiB
Total space used by tapes: 0.0 GiB
Average Compression: 0.0x
And you need to compare the "Modification Time" on source and target.
If target time is higher than source, the tape is replicated.
Best
perew
3 Posts
0
September 19th, 2016 06:00
Since the 2 VTLs are communicating, we were hoping for a single command that would show the barcode replication status. The process you've outlined involves retrieving this information from both VTLs, parsing out the timestamps, then comparing them. That's doable, but not quite a one-stop solution.