Unsolved
This post is more than 5 years old
70 Posts
0
3108
LCC
Hi all,
Does anybody knows a command to Enable the LifeCycle Controller from remote tasks?
During upgrades i received a message that LCC was in recovery mode so i had to enable it by hand. But before we upgrade the whole environment, i would like to know if there are more LCC's in recovery mode.
So it would be nice if there is a command to do so.
Thx in advance.
DELL-Shivendra K
685 Posts
0
May 10th, 2017 04:00
Hi, thanks for the query.
You can use following racadm command to enable LC:
racadm set LifecycleController.LCAttributes.LifecycleControllerState 1
Hope it helps!
TechnicalEngineeringKLM
70 Posts
0
May 10th, 2017 05:00
Thx Shivendra
I will use that to check and set the Value.
Do you know what the is reason the LCC goes into recovery mode? what causes that?
DELL-Shivendra K
685 Posts
0
May 11th, 2017 00:00
Folks on below forum (general systems management) should be able to help with that:
en.community.dell.com/.../4469