Unsolved
This post is more than 5 years old
36 Posts
0
27704
DELL 8300 XP Pro Problems,
I have gotten my original Hard drive back to it's original size and have been adding the programs I want. The problem I am having is the lower hard drive which is a 500GB one for my extra toys on it reads Drive C:and my 80 GB drive reads drive D: It works fine except for when I start up it takes about 3 to 5 minutes before the screen comes on. What am I missing that needs to be done to have it start up normally??
rdunnill
6 Professor
6 Professor
•
8.8K Posts
1
January 31st, 2015 09:00
Does this happen with the lower hard drive disconnected?
John J Kushner
36 Posts
0
January 31st, 2015 12:00
Thgat is what is so confusing. When I disconnect the lower hard drive it will not even boot up. I tried trading places and even the ribbon but to no avail.
rdunnill
6 Professor
6 Professor
•
8.8K Posts
0
January 31st, 2015 14:00
An easy way out would be to replace the two IDE drives with a single SATA drive, like this $55 Western Digital Blue, and imaging over or reinstalling XP.
Meanwhile, If you press F12 at bootup, do you get a boot menu with your two hard drives listed?
RoHe
10 Elder
10 Elder
•
44.3K Posts
0
January 31st, 2015 17:00
Is the 80 GB drive listed first in the boot sequence in BIOS setup?
If BIOS is set to allow booting from USB, you might want to try changing that to "USB: No Boot".
Are both hard drives jumpered for "cable select"? Dell systems don't like drives that are jumpered as Master and Slave. The boot hard drive should be connected to the end connector on the IDE ribbon cable and the other HDD to the middle connector on that ribbon.
John J Kushner
36 Posts
0
February 1st, 2015 04:00
Neither drive is listed in bios
Both set to cable select
ribbon connectd as stated
?????????????
RoHe
10 Elder
10 Elder
•
44.3K Posts
0
February 1st, 2015 15:00
If neither drive is listed in BIOS, something is wrong...
Have you tried clearing BIOS?
*If motherboard battery is more than ~2-3 years old, this might be a good time for a new one. 3-volt CR2032 lithium ion battery, ~$2-$3 at discount stores.
John J Kushner
36 Posts
0
February 1st, 2015 16:00
will give it a shot tomorrow n ty
John J Kushner
36 Posts
0
February 2nd, 2015 15:00
OK puit the new battery in and followed instructions when I rebooted at least it told me that the 80GB drive was Master n the 500 GB Drive was slave but it still reads the opposite of what they are D=OS , C= toys on big drive. I also tried undoing the 500 and it will not start up and that is a pain as I could take it out as I have the smaller USB drives that work just as good? Also reversed them and it took the 2 min but xp did start up. I would like to know what the heck is wrong as I am really confused as this box is still a good running machine...well it was till I tried putting Linux on the drive next to XP. That is all now gone so what next besides throwing it against the basement wall.:)
RoHe
10 Elder
10 Elder
•
44.3K Posts
0
February 2nd, 2015 16:00
Sounds like Windows XP probably got assigned drive letter D: on 80GB drive when you installed Linux.
Follow the procedure here to reassign drive letter C: to the boot drive and D: to the 500 GB. You'll first have to assign the 500 GB (currently C:) to some new drive letter to free up C: and then assign the 500 GB to D: after you assign C: to the 80 GB. Read and follow the instructions carefully at that link. If you do it right, your 80 GB should become C: and the other drive D:.
Words of caution: you will be editing the Registry. Be sure to back up the entire Registry onto a USB stick before you make any changes to the Registry. And back up any personal files on the 80GB drive too. I take no responsibility if you fail to back up and then crash Windows.
If all else fails, you may have to disconnect the 500 GB drive, boot from your Dell Windows Reinstallation disk and do a clean install of XP on the 80 GB drive. Once XP is fully reinstalled with drivers, Service Pack(s), updates and hotfixes, you can reconnect the other drive.
Keep in mind that Microsoft is no longer supporting XP, and there won't be any new security patches or other fixes for Windows or IE8. So you might want to consider upgrading to Win 7 instead of doing a clean install of XP. You will have to buy a valid license for Win 7 to run it on this system.
John J Kushner
36 Posts
0
February 22nd, 2015 17:00
Ok that didn't work and blew the windows up so I took the 80 out n formatted the 500, I have all backed up no worries there, and did a clean install on it and it went nicely until I rebooted.
DELL 8300 Dimension
Bioa A07
Dell.com
Primary disk 1 not found to continue strike F1 or F2 to run setup.
New Csmos battery but will buy another just in case and have looked in bios and all seems fine so any suggestions would help.
I am tempted to hook up the 80 as it had it on it as well.
RoHe
10 Elder
10 Elder
•
44.3K Posts
0
February 22nd, 2015 19:00
Is the 500 GB drive connected to the end connector on the ribbon cable? It should not be on the middle connector of that ribbon.
Is the 500 GB recognized in BIOS setup?
John J Kushner
36 Posts
0
February 23rd, 2015 08:00
yes it is and now am back to no F1 and picking between windows XP or windows default. Is there a way I can eliminate this start up choices?
RoHe
10 Elder
10 Elder
•
44.3K Posts
0
February 23rd, 2015 13:00
John J Kushner
36 Posts
0
February 23rd, 2015 14:00
did that and only 1 was listed?????
RoHe
10 Elder
10 Elder
•
44.3K Posts
0
February 23rd, 2015 16:00
:emotion-12:
Right-click My Computer, and then click Properties.
Be sure to save the copy of boot.ini in a different folder than where it exists now, and remember where you put it. Then post a copy of the boot.ini file you just saved here.