This post is more than 5 years old
2 Posts
0
3304
How do I use a network card other than the built in one on motherboard in Dimension 2400?
My 2400 network is very slow, I want to use a 10/100 ethernet card but how do I tell the 2400 to use the card I installed?
terry46
2 Posts
1
October 20th, 2011 11:00
Thanks for the info. Also you might try Advanced system care also, does a great job!
fireberd
9 Legend
9 Legend
•
33.3K Posts
0
October 20th, 2011 08:00
The built in NIC is a 10/100. You can disable the built in (Integrated) network controller in the Setup (BIOS). F2 at POST will allow you to access the Setup.
However, it may not be your NIC that is causing whatever "slow network". A bad interface cable, a bad router (if you are using one) or a problem with the ISP's modem or line.
muto
872 Posts
0
October 20th, 2011 08:00
.