Unsolved
This post is more than 5 years old
4 Posts
0
2597
Max and minimum height of the Dell Small Form Factor All-in-One Stand - OSS17
I've contacted my rep and googled the heck out of this to no avail. If someone could get me some dimensions on this stand and what height it might be at minimum vs maximum height, that'd be awesome. Thanks in advance!
speedstep
9 Legend
9 Legend
•
47K Posts
0
August 30th, 2017 11:00
http://i.dell.com/sites/doccontent/shared-content/data-sheets/en/Documents/ecemea-optiplex-5040-technical-spec-sheet.pdf
3040 5040 7040 SFF
11.4 x 11.5 x 3.6
29.0 x 29.2 x 9.26
Dell S2715H monitor
Dimensions with stand (H x W x D):
Height: 445 mm (17.52")
Width: 611.2 mm (24.06")
Depth: 196 mm (7.72") So you add 4 inches for the Computer.
Manufacturer part M7V3M
Dell part 452-BCMX
http://accessories.us.dell.com/sna/products/Docking/productdetail.aspx?c=ca&l=en&s=que&cs=caque1&sku=452-BCMX
Takes1toknow1
4 Posts
0
August 30th, 2017 12:00
Is this the same part as this:
www.dell.com/.../pc-accessories
Takes1toknow1
4 Posts
0
August 30th, 2017 12:00
Thanks. I'm not sure that will work for the OS117 also.
DELL-Chris M
Community Manager
Community Manager
•
54.9K Posts
1
August 30th, 2017 13:00
6P8CR = OSS17 All-In-One Stand, Sales SKU = 452-BCMX, 452-BCPW, 452-BCPX, 469-5408
I cannot find any document that details the height from the desktop surface to the bottom and top reach of the monitor bracket. None of the labs here have this stand. All that is listed on its page is the setup guide. Perhaps you can see one on display at a local store and have them measure it.
speedstep
9 Legend
9 Legend
•
47K Posts
2
September 1st, 2017 08:00
OSS17 and 452-BCMX are one and the same part.
There is no exact dimension Because it depends on What size monitor and the monitor goes up and down as well as tilts forward and back. All dimensions are approximate + or - 1 inch.
Takes1toknow1
4 Posts
0
September 1st, 2017 09:00
So, I went out and measured one yesterday. At it's lowest and you are right, it depends on the monitor size, but the top of the monitor when lowered was flush with the unit. At it's lowest was at 15and 1/4 inches.