This post is more than 5 years old
7 Posts
0
186343
Precision T1500 Motherboard Jumper Pins
I've spent ages searching for which jumpers I should use for power, reset s/w etc but have had no luck so far. Can anyone point me to a motherboard manual or alike please?
TIA
BigBadBenny
7 Posts
0
October 16th, 2013 08:00
After a process of trial and error, plugging in to each pin. I found the the power switch pins are 5-6 and pins 2-4 are the LED.
BigBadBenny
7 Posts
0
October 16th, 2013 08:00
I followed a process of trial and error plugging in the to each of the jumpers and found that pins 5 & 6 are the power switch and 2 & 4 are the LED.
BigBadBenny
7 Posts
0
October 16th, 2013 09:00
After a process of trial and error, plugging in to each pin. I found the the power switch pins are 5-6 and pins 2-4 are the LED.
Wooly Bull
1 Message
1
February 22nd, 2015 08:00
Here is the Dell Precision T1500 motherboard front panel header pinout:
PINS USE
====================
1-3 HDD LED
2-4 Power LED
5-6 Power Button
7-9 Reset Button (or 7-8?)
Dell-Kuldeep M
2 Intern
2 Intern
•
621 Posts
0
October 16th, 2013 02:00
Hi BigBadBenny,
You may refer to the link below for the service manual of your system.
The link is http://bit.ly/15H1Yci.
Check the System-Board Layout on page 46 for the connectors.
Hope this helps. Please feel free to reply for any further assistance.
BigBadBenny
7 Posts
0
October 16th, 2013 03:00
Thanks Kuldeep but does not have the layout of the pins i.e. which two pins are for the power switch, which two are for the reset switch etc.
Dell-Kuldeep M
2 Intern
2 Intern
•
621 Posts
0
October 16th, 2013 04:00
Hi BigBadBenny,
I was unable to find the front panel header diagram for T1500 system model; however you may refer to the link below to view pictures of front panel header for P55 chipset.
The link is http://bit.ly/H146D4.
T1500 comes with Intel P55 or H57 chipset and have the same front I/O panel connectors. Navigate to page 18 of the manual.
Hope this helps. Please feel free to reply for any further assistance.
BigBadBenny
7 Posts
0
October 16th, 2013 04:00
This looks like it might do the job. I'll give this a try later on and let you know.
Thanks for your help :emotion-1:
Dell-Kuldeep M
2 Intern
2 Intern
•
621 Posts
0
October 16th, 2013 06:00
Hi BigBadBenny,
Share the results once you try, if you were able to make the connections or if you face any issues.
I will research more to find any other related information.
Please feel free to reply for any further assistance.
BigBadBenny
7 Posts
0
October 16th, 2013 07:00
Unfortunately this did not work. :emotion-6:
Dell-Kuldeep M
2 Intern
2 Intern
•
621 Posts
0
October 17th, 2013 05:00
Hi BigBadBenny,
Glad to know you resolved the issue.
I appreciate your technical expertise.
Thank you for sharing the information related to the pins for other users to benefit.
Please feel free to reply for any further assistance.