Unsolved
This post is more than 5 years old
24 Posts
0
7657
Studio One 1909 Slow Boot through Dell splash screen
I'm working on a Studio One 1909. When it boots the Dell splash screen comes up and shows a progress bar.
The progress bar hangs for a long time at about 15% .. and eventually finishes.
This seems like odd behavior and I'm wondering if there's something wrong. But, I can't figure out where to look as it all still works.
Is this just normal?
DELL-Srinivas P2
13 Posts
0
July 21st, 2012 10:00
Hello Fred339,
Welcome to the community,
To isolate the issue,
1) Please release the flea power on the computer and check. Turn the computer off. Disconnect all the cables (Power, Network, any peripherals etc.,) from the computer and then press and hold the power button for 10 seconds. Release the button and then connect the power cable. Turn the computer ON and check if the issue is fixed.
2) Update the BIOS on the computer. To update the BIOS, please open the following weblink and then select the operating system installed on your computer and download the Latest BIOS. Download the file and run the file.
www.dell.com/.../555
Please post back if you need further assistance.
Thanks & Regards
Dell_Srinivas_P
Dell Social Media Responder
http://www.facebook.com/Dell
http://twitter.com/#%21/dell
fred339
24 Posts
0
July 21st, 2012 11:00
flea power???
DELL-Srinivas P2
13 Posts
0
July 23rd, 2012 11:00
Hello Fred339,
In technology Jargon flea power is residual electricity or current often stored on circuit boards (in power supplies, mother boards etc) that remains charged even after all power cords and batteries have been removed. To drain flea power, remove batteries and power cords then attempt to 'turn on' your device.
Please post back if you need further assistance.
Thanks & Regards
Dell_Srinivas_P
Dell Social Media Responder
http://www.facebook.com/Dell
http://twitter.com/#%21/dell