This post is more than 5 years old
5 Posts
1
5833
Navisphere can not see host.
We just recently received and setup a CX3-40, when EMC came in they help us attach 3 servers to the CLARiiON. We now have another server I am trying to get working with it but Navisphere will not see the host. The server is running Server 2003, full updated, has a Qlogic QLE2460 fibre card installed, with the approved drivers, the windows hotfix, and SANsuffer installed. The Navisphere host agent is installed on the server, along with PowerPath. The switches are able to see the HBAs that are installed, and the zones are setup. In Navisphere, I go to Tools -> Connect Host, type in the IP of the server I wish it to use, and I get the following error message.
Errors encountered while retrieving information for this host.
Please check the host ip address. Either this host is not managed or is not connected to a CLARiiON storage system.
I have been reading, and re-reading just about everything I can find but I just can't seem to figure out what is going on. My guess is that I am missing some small step some where, but I just can't seem to figure out which one it might be.
Errors encountered while retrieving information for this host.
Please check the host ip address. Either this host is not managed or is not connected to a CLARiiON storage system.
I have been reading, and re-reading just about everything I can find but I just can't seem to figure out what is going on. My guess is that I am missing some small step some where, but I just can't seem to figure out which one it might be.
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
June 25th, 2008 10:00
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
June 25th, 2008 07:00
Home > Support > Product and Diagnostic Tools > CLARiiON Tools > CLARiiON Procedure Generators
LLabs
5 Posts
0
June 25th, 2008 10:00
LLabs
5 Posts
0
June 25th, 2008 10:00
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
June 25th, 2008 10:00
LLabs
5 Posts
0
June 25th, 2008 10:00
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
June 25th, 2008 10:00
DeVoiD1
31 Posts
0
July 18th, 2010 14:00
Hi, this could be part of my problem, I just got a new server, instled all the software, but dont have a regester button on the server utility.
At what ste did you need to go inot he SAN Switch, and what did you have to do there?
IM a newbie on SAN and SAN switches, but when I do IE to the IP on the SA Switch, I see two zones that are being used by the other servers, do I have to do something to put the new server into that Zone on the switch?
here is a link to my post proper
https://community.emc.com/thread/107424
thanks for any help you can offer.
j