Unsolved
2 Posts
0
626
EqualLogic indicating update available even after updated
Good morning everyone.
I have been facing some difficulty with DELL EqualLogic PS6100.
When I click Check for software updade, I get the message that there is an update available.
However, I already did the firmware update, both through the GUI and the CLI. Even if I enter the Dell Storage Update Manager, no update appears and says it is updated.
Has anyone been through this or know what I need to do? I've already reinstalled the firmware and nothing worked.
I thank anyone who can help me.
dwilliam62
3 Apprentice
3 Apprentice
•
1.5K Posts
0
August 11th, 2020 04:00
Hello,
What version did you upgrade to?
Screenshots get scanned so they don't appear immediately after posting.
Did you also see if a drive firmware update was needed?
What about SANHQ? Did you upgrade that to current version as well? v3.4.1?
Regards,
Don
dwilliam62
3 Apprentice
3 Apprentice
•
1.5K Posts
0
August 11th, 2020 06:00
Hello,
I noticed on my 10.0.3 array it did the same. There are other software packages it checks for. The HIT/ME, HIT/LE, SRM, etc..
On an older array non 10.x I got a summary
So the new software does not refer to the EQL firmware but likely one of the other packages.
Regards,
Don
GabzHenrique
2 Posts
0
August 12th, 2020 02:00
Thanks for your answer @dwilliam62
I just installed the firmware, I think it is the most important.
It is strange to say that the last update was made in September 2018.
Does anyone know which one to install to update this information?
dwilliam62
3 Apprentice
3 Apprentice
•
1.5K Posts
0
August 12th, 2020 02:00
Hello,
You are very welcome.
Re: Last Update. Not sure what you are referring to.
Regards,
Don