You can't run 'reset' from the passive controller. As indicated in the error message. The passive controller does not access the disks so it cannot see the configuration to reset it.
Once connected to the primary controller the command should work. This will completely erase all data and configuration information and restore it back to factory defaults!
dwilliam62
3 Apprentice
3 Apprentice
•
1.5K Posts
0
February 25th, 2020 02:00
Hello,
You can't run 'reset' from the passive controller. As indicated in the error message. The passive controller does not access the disks so it cannot see the configuration to reset it.
Once connected to the primary controller the command should work. This will completely erase all data and configuration information and restore it back to factory defaults!
Regards,
Don