Unsolved
This post is more than 5 years old
3 Posts
0
22785
ps 6000 from 6.0.11 to 7.1.7 upgrade
I have upgraded my ps 6000 from 6.0.11 to 7.1.7. after that when I reset my device I get following error
CLI> reset
% Error - Object does not exist
% Error - Object does not exist
Warning: This command resets an array to the factory
defaults (original condition). The result is the
elimination of all group and volume configuration
information and any volume data residing on the array.
It is strongly recommended that you not reset a running
array. Instead, use the delete member command which moves
data from this array to other arrays and automatically
resets this array.
This member Unknown
IP Addresses associated with this member:
Reset this array to factory defaults? [n/DeleteAllMyDataNow]
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
August 10th, 2015 08:00
Hello,
Are you connecting via the serial port? Based on that prompt "CLI>" either you are on the passive CM or that array is not configured. I would try connecting to the other controller's serial port.
If not, opening a support case, would be the next best option.
Regards,
Don
Mtexter
2 Intern
2 Intern
•
207 Posts
1
August 14th, 2015 07:00
Looks to me like you meant to run the "restart" command. Reset will blow away any configuration that exists as well as zero out all of your drives, so don't use that.