This post is more than 5 years old
7 Posts
0
12926
FS7600 Replication
I would like to replicate NAS containers from a primary cluster to a disaster recovery cluster (both ends have FS7600 with dual controllers). Volume replication is working between the PS devices. In Group Manager I click NAS > Configure Replication > Replication partner (the DR group) > OK. The message Remote host is not reachable. From a machine on the iSCSI network I can ping the iSCSI IP addresses of the PS devices at both locations and none of the addresses for the FS devices on the other side of the VPN. I am guessing there is a gateway issue and I do not see where the gateway is for the FS (does it pull it from the group config for iSCSI)
quelx
7 Posts
0
May 8th, 2013 08:00
The primary site is 192.168.0.0/24 and DR site 192.168.1.0/24 for SAN/iSCSI traffic with the NAS management addresses 192.168.x.10.
I was directed to page seven of Dell EqualLogic NAS Replication Network Setup Guide.
So I needed to do the following:
ssh grpadmin@192.168.0.10
static-routes add 192.168.1.0 192.168.0.1 Management –netmask 255.255.255.0
and
ssh grpadmin@10.1.1.140
static-routes add 192.168.0.0 192.168.1.1 Management –netmask 255.255.255.0
I did not see an option to add the gateway to the NAS's SAN addresses in the Group Admin GUI.
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
May 7th, 2013 17:00
Hello,
You have to set it specifically , if you click on network tab after clicking NAS-cluster. Also make sure
the gateway is pingable from NAS cli