Unsolved
This post is more than 5 years old
4 Posts
0
2372
Using ImageAssist for the first time. Dont want a recovery partition
I'm not sure where I am missing this but I want my OS partition to use the entire hard drive. I am ending up with a 60gb recovery partition when I use my usb key to restore a Image Assist captured wim.
Where can I change this?
Dell Image Assist
26 Posts
0
June 1st, 2017 11:00
Hello,
can you provide the logs from the following location, email to US_OSImaging@Dell.com
%WINDIR%\System32\Sysprep\Panther
Location of Sysprep logs.
%WINDIR%\Panther\DTRI\Logs
Location of Image Assist logs.
Thank you,
Daniel
azuberi
4 Posts
0
June 2nd, 2017 02:00
This may help someone else out. My Hyper V VM was creating this recovery partition and it was only visible through disk management on the VM.
The fix was to use Disk Part to delete the recovery partition and extend the primary OS partition to the full size of the drive on the VM and then capture using Image Assist.
Dell Image Assist
26 Posts
1
June 2nd, 2017 05:00
I would also suggest restoring the image to platforms of your liking to confirm the OS is Valid.
thank you,
Daniel