Unsolved
This post is more than 5 years old
17 Posts
0
22158
Strange L400 problem
Hi guys,
I bought an L400 a while ago. No OS on it, but I could open the setup pages via the F2 key.
I have now got myself an 10NRN cable and have connected the CDrom for installation of an W2K OS. Nothing happened. I then tried a floppy boot disk, again nothing happened. I tried to get into setup again and couldn't. I reset the L400 after taking out the battery and unplugging the power cable, via the small hole on the back above the battery compartment. Held for at least five seconds. Still can't get into setup.
I took out the HDD and put it in an older Lattitude CP and formatted the HDD. Put it back in the L400 and I still have the same problem.
I know the L400 HDD is ok because I also tried and succesfully set up W2K on the CP then reformatted after.
Does anyone have any ideas or suggestions please?
Regards,
Kevin
Edit. Sorry if this is in the wrong place.
Message Edited by KBL on 04-16-2007 04:05 PM
AussieChris
4.2K Posts
0
April 20th, 2007 20:00
KBL
17 Posts
0
April 20th, 2007 21:00
Message Edited by KBL on 04-20-2007 05:16 PM
AussieChris
4.2K Posts
0
April 21st, 2007 20:00
KBL
17 Posts
0
April 22nd, 2007 09:00
Message Edited by KBL on 04-22-2007 12:07 PM
AussieChris
4.2K Posts
0
April 23rd, 2007 18:00
KBL
17 Posts
0
April 24th, 2007 08:00
Message Edited by KBL on 04-24-2007 04:51 AM
KBL
17 Posts
0
April 25th, 2007 13:00
Message Edited by KBL on 04-25-2007 10:23 AM
AussieChris
4.2K Posts
0
April 27th, 2007 14:00
KBL
17 Posts
0
April 27th, 2007 16:00
Message Edited by KBL on 04-27-2007 12:33 PM
KBL
17 Posts
0
April 30th, 2007 22:00
Message Edited by KBL on 04-30-2007 06:35 PM
KBL
17 Posts
0
May 7th, 2007 21:00
AussieChris
4.2K Posts
0
May 8th, 2007 06:00
KBL
17 Posts
0
May 8th, 2007 11:00
KBL
17 Posts
0
May 18th, 2007 08:00