VOSTRO 3560 BEEP ERROR CODE

Question

I have a vostro 3560, and turn it on after passing the initial checkup gives me a beep followed by silence and again on beep, no video signal gives and does nothing. which could be wrong with this machine ?. The beep error code is only 1 continuous beep with the same time separation between the two beep, while not turn off the machine, the same sequence is repeated beep. Thank you

VinOth_VingO · Answer

Check out below the following error codes failure description,

wslcu · Answer

,The beep error code is only 1 continuous beep with the same time separation between the two beep while not turn off the machine, the same sequence is repeated beep

VinOth_VingO · Answer

Bad Motherboard - 1 long and 1 short beep
Disk drive related problem / Video card problem - 1 short beep then nothing happens
Bad video card - 1 long and 2 short beeps
Bad power supply - 1) continuous beeps, 2) non-stop short beeps
Bad memory - 3 short beeps

1 beep only continuous - Refresh failure

try reseating the memory, if the error still occurs, replace the memory

Dell Pre-Boot System Assessment (PSA):

Restart your computer
When the Dell logo screen appears, press F12 several times to open the One-Time Boot menu.

Note: If the One-Time Boot menu does not open, wait for the Windows
login screen to appear. Then restart your computer and try again.

3. Use the Down Arrow key to select Diagnostics (or PSA+ or Enter ePSA), then press Enter to begin the assessment.

4. Write down any error codes listed on your screen.

5. Use the Dell Interactive Support Agent to get information on the error
codes listed in the PSA

Locked Topics – Laptops General

Was this post helpful?