Unsolved
This post is more than 5 years old
614 Posts
0
517
Powerpath error and VNX OE upgrade
Hello,
After the 2nd reboot of SPA, due to an LCC-card which would load the new firmware, one of our hyper-v hosts rebooted. The windows got a strange powerpath error. I have attached a picture, and any feedback would be appreciated. The server is running windows 2012.
Thanks in advance,
Admingirl
Mich
86 Posts
0
July 28th, 2014 14:00
Those PowerPath events are ID 100 which would normally list as "Path path_name to device_id is dead". In your case c1t0d5 to array APM00123300963.
This error would be expected if you lost paths to an SPA.
If the server rebooted though, then I would recommend opening a case with Tech support and having the EMCReports checked.
The Event log should display the correct information if you have RDPd to the actual server and not using ServerManager remotely connected. Again I recommend opening a case with support to check this as well.
Regards, Michel.