Unsolved
This post is more than 5 years old
23 Posts
0
935
Can't label Tape on GUI show "Pool are in use" but can label on CLI
Can't label Tape on GUI , show "Pool are in use" but can label on CLI by same pool with GUI
Thanks
Anurak Jongjairak
Unsolved
This post is more than 5 years old
23 Posts
0
935
Can't label Tape on GUI , show "Pool are in use" but can label on CLI by same pool with GUI
Thanks
Anurak Jongjairak
Top
rovinabi
55 Posts
0
October 18th, 2010 00:00
Hi Anurak,
You might have to be a little more clearer in explaining your issue here to get a response.
anurak13
23 Posts
0
October 18th, 2010 10:00
Hi Rovinabi,
I use Jukebook SUN SL500
before I can label on GUI nomally until 2 week ago ,I can't label on GUI show pop up message "Pool are in use"
I tested change to any pool but can't label show pop-up meessage "pool are in use"
I tested use command line by nsrjb -L -b[pool] -S1-20 it work any pool
Anurak jongjairak
rovinabi
55 Posts
0
October 18th, 2010 22:00
Anurak,
Can you try labeling the pools again, but this time ensure that you are not highlighting any of the drives? Just go to the volume field in NMC -> Media -> Jukebox -> . Then try a label (Dont select any drives in the Label pop up either, leave it as automatic).