IBM3573L4U

I see that this.

100x,

I think you will find the info you need on Page 90 of 151 in the Hardware compatibility guide: -

TS3200 (3573) IBM LTO-4 (FC, SAS) or IBM LTO-4HH (SAS) as I believe the "L4U" stands for LTO 4 Ultrium.

Regards,

Bill Mason

100x,

I apologise - I now see your issue that the AIX column is not marked, I thought your issue was you could not find the entry for this due to the way it was referenced - sorry.

I will check later today to see if this is an omission within the Guide which we can get corrected of if there is a specific reason why it is not supported.

Regards,

Bill Mason

100x,

I have checked internally within EMC and have received the following comments back: -

The problem here is that the drive and library section in the HCG is not in-sync. If the drive is support on AIX and the library support the drive, then we should add the AIX OS in the library section too. I’ll make the necessary fix right now, but it won’t reflect the changes until the end of the month. Unless we re-publish the HCS again.

It is an oversight on our part which we will correct going forward, your environment is supported therefore you can continue as planned. Sorry for any confusion caused.

Regards,

Bill Mason

Now,my  OS is AIX 5.3.10, Networker Version is 7.5.2.After installing the software,When i labeling the tape,the tape library Often  go to offline.After several minutes,it automatically turn OK.

Here are some error messages:

31916 06/04/10 12:50:37  2 0 0 1 364652 0 saperp1_per nsrmmgd Disabling jukebox `IBM@0.3.1' due to a configuration problem. Correct
the problem and re-enable the jukebox resource.

0 06/04/10 13:46:52  2 0 0 1 348600 0 saperp1_per nsrmmgd lcpd 1 at host saperp1_per reported error 'Jukebox:IBM@0.3.1 access:scside
v@0.3.1 failed:INIT ELEM STATUS key:2 status:CHECK CONDITION UNKNOWN, Logical Unit Is in Process Of Becoming Ready' for the command
`11'.

42506 06/04/10 11:40:18  2 0 0 1 402226 0 saperp1_boot1 nsrd media warning: Jukebox `IBM@0.3.1' Hardware status of jukebox 'IBM@0.3.
1' changed from 'ready' to 'cannot access the hardware'

0 06/04/10 13:47:22  2 0 0 1 348600 0 saperp1_per nsrmmgd mgd_process_admin_response: failed to process response for command 11 from
lcpd 1 at host saperp1_per with error 'Jukebox:IBM@0.3.1 access:scsidev@0.3.1 failed:INIT ELEM STATUS key:2 status:CHECK CONDITION
UNKNOWN, Medium Magazine Removed'.

===========

The IBM Engineer check the hardware,he say the hareware is No problem.