This post is more than 5 years old
14 Posts
0
1527
NMM 2.4.0.383 HyperV Granular Restore
Hi folks,
I have installed NMM version 2.4.0.383 with feature Granular Level Recovery in the Server 2008 R2 Enterprise with Hyper V.
I have client backup level full with following configuration:
APPLICATIONS:\Microsoft Hyper-V\Initial Store
APPLICATIONS:\Microsoft Hyper-V\my_client_name
When I go to do granular restore received the message:
SSID 3132501497 is not GLR compatible. Error: Device type 'LTO Ultrium-3' for SSID 3132501497 is not GLR compatible.
Could you help me?
Thanks,
Alessandro.
TimQuan
1.2K Posts
0
August 20th, 2013 18:00
There are a few limitations for Hyper-V GLR. Please refer to NetWorker Module 2.4 SP1 for Microsoft Applications Application Guide Page 274 "Granular level recovery".
2 Attachments
NetWorker Module 2.4 SP1 for Microsoft Applications Application Guide.pdf
NetWorker Module 2.4 SP1 for Microsoft Applications Administration Guide.pdf
TimQuan
1.2K Posts
1
August 20th, 2013 18:00
There are a few limitations for Hyper-V GLR. Please refer to NetWorker Module 2.4 SP1 for Microsoft Applications Application Guide Page 274 "Granular level recovery".
1 Attachment
NetWorker Module 2.4 SP1 for Microsoft Applications Application Guide.pdf
tbrtbr
14 Posts
0
August 21st, 2013 06:00
I have NetWorker Server version 7.6.5.2.Build.1187.
NetWorker Module 2.4 SP1 need minimum 8.0.1 Networker Client.
Can I install 8.0.1 Networker Client working with NetWorker Server version 7.6.5.2.Build.1187?
Thanks,
Alessandro.
TimQuan
1.2K Posts
1
August 21st, 2013 18:00
NMM 2.4 SP1 requires NW Server 7.6.2 or later, 8.0 or later; NW Client 8.0 SP1 or 8.0 SP2.
Yes, NW Client 8.0.x can work with NW Server 7.6.x.They are compatible.
tbrtbr
14 Posts
0
August 29th, 2013 06:00
Hi,
I installed networker client version 8.0.2 with NMM version 2.4.1.92.
I did backup full again.
However I can not do restore granular.
CarlosRojas
1.7K Posts
1
August 30th, 2013 00:00
Hi Alessandro,
The problem is not related to your NW or NMM version but to the backup device.
GLR is supported only on Data Domain or AFTD devices (could be also AFTD on Data domain), but it's not compatible with tape devices.
As a test, and if you have enough storage in the NW server itself, create an AFTD on the NW server, and run a full backup. Then try to perform the GLR from the backup saved on the AFTD and that should work fine.
Thank you,
Carlos
tbrtbr
14 Posts
0
October 23rd, 2013 11:00
Hi Carlos,
I did what you suggested and it worked.
As I do not have space in the Networker server, I used CIFS-mounted AFTD on Windows servers and storage nodes.
Thank you very much.
Alessandro.