This post is more than 5 years old
110 Posts
0
3329
NW 8.0 - Storage node not ready when doing tape inventory
Hello all
OS: Windows 2008 R2 x64
NW: 8.0
Tape libraries:
1 Physical Dell with 3 IBM LTO-3 drives
2 VTLs emulating Scalar i40/i80 with LTO-3 drives
Problem:
When trying to do a tape inventory the result is sometimes ok when trying 1 or 2 tapes.
When trying to do more than 2 tapes at once the result is always failed.
The error message is: Storage node 'hostname' is not ready
The behaviour is the same on all libraries.
Have enabled peristent naming in the registry, rebooted and re-added all 3 libraries.
Any ideas ?
Have resgistered a SR but they are slow to respond.
Thanks
Eivind A
eivinda
110 Posts
0
November 13th, 2012 00:00
Hello
Sorry for not updating this thread until now.
The issue is as you say a known bug in 8.0.0.1
I upgraded to 8.0.0.3 and the problem was solved.
Thanks
Regards
Eivind
coganb
736 Posts
1
October 26th, 2012 02:00
Hi,
You should try doing this from the command line in verbose mode to try to get a more coherent error message: nsrjb -Ivvvv. Also have a look through this document which will help you identify if there are any hardware and/or connection issues.
https://community.emc.com/docs/DOC-16264
-Bobby
CarlosRojas
1.7K Posts
1
November 12th, 2012 08:00
Hi Eivind,
I think this could be related with a known issue.
Are you finding any core in the storage nodes for nsrsnmd?
If so I would suggest you to open a case with support and request the fix for NW141817
Thank you.
Carlos.