Unsolved
This post is more than 5 years old
27 Posts
0
1518
Problems with EMC Networker 9.2 and Hyper-V
Hello,
I am running EMC Networker 9.2 and am constantly having trouble when running Hyper-V backups.
My topology is as follows:
- storage node FC attached to DD, using DD Boost
- Hyper-V standalone cluster that I wish to back up to the SN above
Although the DD is accessible only over FC, all other Standalone Hyper-V servers have client direct and block based backups enabled.
When I try enabling Client Direct and block based backups for the my new Hyper-V server, I get the error below
Unable to perform backup for save-set ID '' with DIRECT_ACCESS=Yes, check device and pool configuration to enable Client direct
Filesystem backups run just fine with Client Direct disabled, but I am not able to make Hyper-V backups complete successfully with Client Direct enabled or disabled.
I am also certain that the policy is correctly configured and that there is end to end connectivity between client, SN and server.
Please advise.
Thanks,
Bogdan
CarlosRojas
1.7K Posts
0
September 25th, 2018 05:00
Hi Bogdanionut.badea
Silly observation but, when selecting CLient DIrect, do you select interface FC or ANY or do you have it set to "IP"?
Thank you,
Carlos
Bogdanionut_bad
27 Posts
0
September 25th, 2018 06:00
Hi Carlos,
Do you mean if I select DD Backup and whether I tick the FC backup or not ?
If so, no, I do not select DD Backup, nor do I tick FC. All other Hyper-V backups run fine without this.
Thanks,