Unsolved
This post is more than 5 years old
2 Posts
0
777
Configuring S4810 as a FIP Snooping Bridge(FSB)
Hi All,
I am trying to setup a S4810 switch as an FSB uplinked to a Brocade FCF.
I have followed the admin guides and the following deployment guide --
But I cannot get the FSB to initiate the FIP discovery process.
Here is my configuration on the S4810 --
Port TE0/1 -- uplink to Brocade FCF
Port Te 0/16 -- CNA
Dell-S4810#sh run Current Configuration ... ! Version 9.11(0.0) ! Last configuration change at Fri May 4 16:42:09 2018 by default ! boot system stack-unit 0 primary system: A: boot system stack-unit 0 secondary system: B: ! hardware watchdog ! logging coredump stack-unit all ! hostname Dell-S4810 ! protocol lldp ! redundancy auto-synchronize full ! cam-acl l2acl 4 ipv4acl 4 ipv6acl 0 ipv4qos 2 l2qos 1 l2pt 0 ipmacacl 0 vman-qos 0 ecfmacl 0 fcoeacl 2 ! stack-unit 0 provision S4810 interface TenGigabitEthernet 0/1 no ip address mtu 2500 portmode hybrid switchport fip-snooping port-mode fcf dcb-map fcoe ! protocol lldp no advertise dcbx-tlv ets-reco dcbx port-role auto-upstream no shutdown ! interface TenGigabitEthernet 0/16 no ip address mtu 2500 portmode hybrid switchport dcb-map fcoe ! protocol lldp dcbx port-role auto-downstream no shutdown ! interface Vlan 1 mtu 2500 untagged TenGigabitEthernet 0/1,16 ! interface Vlan 23 no ip address mtu 2500 tagged TenGigabitEthernet 0/1,16 fip-snooping enable no shutdown ! service-class dynamic dot1p ! dcb enable ! dcb-map fcoe priority-group 1 bandwidth 50 pfc on priority-group 2 bandwidth 50 pfc off priority-pgid 2 2 2 1 2 2 2 2 ! feature fip-snooping ! end
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
May 4th, 2018 15:00
Hi,
Can you private message me the service tag? Are you able to upgrade the firmware to 9.13? Is it giving you any error messages?
subhishp
2 Posts
0
May 7th, 2018 09:00
I have PM'd you the service tag.
I cannot obtain version 9.13 of the software. Are there any known issues in 9.11 with regards to FSB functionality?
Thanks,
Subhish
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
May 7th, 2018 10:00
I do not see any known issues, so if you can’t update that should be fine, I don’t see anything in your configuration that explains why it isn’t working.