This post is more than 5 years old
3 Posts
0
2720
DHCP Relays Dell S3100 Series Switch Issues
I have a Cisco core, I am integrating Dell into my network because I have heard great things. I need to set up DHCP Relays on my vlans (coming from a cisco background) and found that it has to be applied at the interface not the Vlan. I tried to apply it to my interfaces and I get "interface not in layer 3 mode". So this is my problem, am I to put all my ports into Layer 3 to get my relays added? This is on Dell S3148P switches.
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
May 2nd, 2017 14:00
An interface needs to have an IP address to be considered layer 3. I would think that you could apply an IP address to a vlan and enable ip helper on that VLAN interface. Have you tried that?
Page 246 of the user guide has some information on DHCP relay, followed by an example configuration.
http://dell.to/2jOfAOQ
afilice
3 Posts
0
May 5th, 2017 09:00
I was able to add it to the vlan interface without issues. I think I mis-read something in the set up guide. thanks for the reply!