Unsolved
19 Posts
0
1083
Dell S4048 stacking/management question
Got a question around 2 stacked S4048's and management access. So I have an ip address on management 1/1, well call it 10.50.1.10/24 and then a management route that is "management route 0.0.0.0/0 ManagementEthernet" We also use Radius/Tacacs for logging on. When node is the active node all works as expected however when I failover to the secondary node "redundancy force-failover stack-unit" it all goes a bit wrong. 1. It takes about 20 failed pings before the management ip address starts responding - this is wrong it is too long 2. When you attempt to login it will not process the Radius/Tacacs but you have to login with a local account - This is also wrong 3. When you do pass the credentials it comes up in standby and you have to use the "telnet-peer-stack-unit" to access the active node and then it still wont process the Radius/Tacacs login but you have to login locally - This too is wrong. What is needed to fix these issues ?
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
June 25th, 2019 10:00
Hi,
What version is the firmware at? Can you check to see if the hardware watchdog is enabled?
remote-exec wdogctl
it should show mmcx0, 60 second period
GoKiwi64
19 Posts
0
June 26th, 2019 03:00
Hi,
Version is
Dell EMC Real Time Operating System Software
Dell EMC Operating System Version: 2.0
Dell EMC Application Software Version: 9.14(2.0)
Copyright (c) 1999-2019 by Dell Inc. All Rights Reserved.
Build Time: Fri Apr 26 09:57:57 2019
Build Path: /build/build01/SW/SRC
Dell EMC Networking OS uptime is 6 day(s), 21 hour(s), 2 minute(s)
System image file is "system://B"
System Type: S4048-ON
Control Processor: Intel Rangeley with 3 Gbytes (3201302528 bytes) of memory, core(s) 2.
8G bytes of boot flash memory.
2 54-port TE/FG (SK-ON)
96 Ten GigabitEthernet/IEEE 802.3 interface(s)
12 Forty GigabitEthernet/IEEE 802.3 interface(s)
However I cannot get that "wdo" command to run
Han-SVH-DS3#wdogctl
^
% Error: Invalid input at "^" marker.
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
June 26th, 2019 09:00
Ok, in that case can you see if there are any errors in the logs around the failover time?