Unsolved
This post is more than 5 years old
1 Message
0
125410
March 25th, 2015 06:00
How to show Dell Powerconnect running config without breaks in the cli
Hello,
I usually work with Cisco switches where I can type "term len 0" before executing "show run" to get a full output of the running config without any pause/breaks. Unfortunately, this command doesn't work on the Dell PowerConnect 6248 i'm working with. When I show the running config I get a --more-- or quit(q) output ever 10 or so lines. I've been googling my *** off and reading through the Dell CLI User Guide and haven't found anything.
Thank you
No Events found!
vt1012
212 Posts
0
March 25th, 2015 09:00
You may want to try the "all" or "/all" option after "show run". I'm not sure if this will work, and it may actually provide more information that you are looking for, but worth a try. This is / was an option on some switches and it seems that it may have provided a continuous readout.
-B