N2048 change management - VLAN1 - to enable routing

 Hi,

Here is some documentation on vlan routing Page 790 http://downloads.dell.com/manuals/common/networking_nxxcli_en-us.pdf

You can route vlan 1 this way.

Hey Josh, many thanks for this all routing is working as expected! The next issue I have is a new leased line/firewall device and the switches routing next hop/IP route @ Dell Switches not getting internet, it is plumbed into VLAN2: interface vlan 2 ip address 192.168.254.253 255.255.255.0 bandwidth 10000 The IP route set on the switch (address of the firewall): ip route 0.0.0.0 0.0.0.0 192.168.254.254 5 And the physical port config: interface Gi1/0/47 spanning-tree portfast switchport mode trunk switchport trunk native vlan 2 switchport trunk allowed vlan 2,99 exit When I connect a laptop directly to the firewall I get internet. When I VPN to the new firewall, all internal routing to the VLANs on the Dell switches works. It just doesn't work when plugged directly into the switch. The routes at the firewall are set 192.168.3.0/24 InternalGW - 192.168.254.253 LAN Dot3Route 192.168.0.0/24 InternalGW - 192.168.254.253 LAN Dot0Route 0.0.0.0/24 WANGW - 193.117.151.21 WAN All Outgoing Any help would be much apprecated. Thanks david