Unsolved
12 Posts
0
1475
N2048 change management - VLAN1 - to enable routing
Hey all,
I need routing enabled on VLAN1 - which is default management - on N2048 switches.
I have done a helluva lot of CLI to mimic an older generation setup so would not want to start again ideally. What is the easiest/quickest route to achieve this?
Many thanks!
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
December 31st, 2018 09:00
Hi,
Here is some documentation on vlan routing Page 790 http://downloads.dell.com/manuals/common/networking_nxxcli_en-us.pdf
You can route vlan 1 this way.
Coops7
12 Posts
0
January 22nd, 2019 02:00