Unsolved
2 Posts
0
974
Network Stack errors on loading Startup-Config
Hello all, I have a stack that consist of a N3024, N3048 and a N3048P. This morning I issued a re-load command (like I have done countless times before). The stack came backup but my network was dead. After connecting in via the Console and ordering another reload I discovered that the switch only loaded the first 135 lines of my 2000+ lines config. I received the following: "The following lines in "startup-config" failed: followed by the rest of the startup-config.
Active image version is: 6.3.2.7
Does anybody know why this might happen and better yet how to keep it from happening again?
thanks,
Bill
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
March 25th, 2019 09:00
Hi,
Were there any changes to the switch when the reload happened? You may want to try the latest firmware https://www.dell.com/support/home/us/en/19/drivers/driversdetails?driverid=ypxx3&oscode=naa&productcode=networking-n3000-series