Unsolved
1 Rookie
•
23 Posts
0
941
[OS10] What's wrong with my IBGP settings?
Hello, I am practicing BGP with a Dell switch.
I set up ibgp in the dell demo center, but it keeps coming out only in idle state.
I simply connected two switches and set neighbor to loopback0
BGP session was established without any problem in EBGP setting, but what is the problem with IBGP?
DELL-Joey C
Moderator
Moderator
•
3.4K Posts
0
October 4th, 2021 00:00
Hi @dell_sss,
I relatively bad at networking, so I went on with looking at the user guide. I may think that the BGP needs to be activated. That's all that I can help on. Here's the guide: https://dell.to/3FfGgkQ
bealdrid2
117 Posts
0
October 4th, 2021 07:00
Since BGP neighbors don't have to be directly connected, do you have a route to the loopback addresses present in the routing table? Typically you'd do this with your IGP, or you could probably use a static route. You may also need to set the "next-hop-self" option under the iBGP config.