This post is more than 5 years old
5 Posts
0
15062
Powerconnect 3524
I am a rookie so please dont beat me up. I just bought powerconnect 3524 last week. After connecting I realized that I need to configure interface port (e1) to only allow 80 http and 443 https other will be either drop or rejected. How can I accomplish that with this unit?
DELL-Willy M
802 Posts
1
October 12th, 2012 13:00
Page 277 discusses options for setting up thru the GUI.
support.dell.com/.../en_ug.zip
DELL-Willy M
802 Posts
0
October 12th, 2012 13:00
You can set up ACLs to block specific traffic. Page 91 starts the discussion about writing ip access-list and applying them to an interface.
support.dell.com/.../en_cli.zip
You would want to write a permit statement for each protocol then there is an implied deny statement that should block all other traffic that does not match the statements that you manually provide.
Hope this help,
Keep us updated if you can.
bobbymale
5 Posts
0
October 12th, 2012 13:00
Anything from the UI? I am a .net programmer and I hate command. Sorry.
bobbymale
5 Posts
0
October 12th, 2012 14:00
So close, but what is hold time? I dont see tcp or udp.