Unsolved
This post is more than 5 years old
1 Rookie
•
40 Posts
0
2176
May 13th, 2019 04:00
Powerconnect 5548 VLAN Setup with Pfsense router and unifi AP
Hi all,
I have a pfSense firewall at home and a UNIFI AP-AC-LR with PowerConnect 5548.
In pfSense I created a VLAN 20 based on my LAN interface and created DHCP server for the VLAN interface and created the Firewall rule to go out to the internet.
In UNIFI controller, I created a VLAN Only network and set the VLAN 20. I then created a wireless network and in the advance option set ‘user VLAN’ with the VLAN 20.
In PC5548, I set port 10 to 'general', PVID 20 and vlan1(see screenshot)
I can connect to the wireless but I have no internet.
Can this be because my UNIFI controller is hosted in the cloud and not in the house or something wrong with my switch configuration?
Thank you
Thank you in advance
DELL-Josh Cr
Community Manager
•
9.7K Posts
•
43.4K Points
0
May 13th, 2019 10:00
Hi,
Are you connecting the 5524 to the pfsense router wirelessly or are they physically connected?
fred974
1 Rookie
•
40 Posts
0
May 14th, 2019 02:00
Hi,
The pfSense is connected to port 37 on the 5548 and the AP on port 17 on the switch
DELL-Josh Cr
Community Manager
•
9.7K Posts
•
43.4K Points
0
May 14th, 2019 09:00
Both ports are in general mode with a PVID of 20?
fred974
1 Rookie
•
40 Posts
0
May 14th, 2019 12:00
Hi,
The ports are in access mode.
Should I be setting it to general/trunk?
pfSense is giving multiple vlan so I am assuming I need to set that port to 'trunk' mode but not sure whart setting to create.
Thank you
DELL-Josh Cr
Community Manager
•
9.7K Posts
•
43.4K Points
0
May 14th, 2019 13:00
Ideally ports that connect to client devices are access mode and trunk or general mode for other networking equipment.